Garage door won't close: sensor repair in Rumson

A door that starts down and comes straight back up is nearly always telling you about its safety sensors.

Call (848) 272-3411

In short

Blinking sensor light, door reversing, or a door that only closes while you hold the wall button: all three point to the photo-eye sensors. Clean and realign them first. If that doesn't work, call, and a technician in Rumson repairs the sensors and re-tests the opener's safety system.

Wi-Fi garage door opener mounted on the ceiling

Doors that won't close in Rumson

Rumson is a peninsula between two tidal rivers, the Navesink and the Shrewsbury, and salt air reaches every street. On the waterfront along both rivers, sensor brackets rust and wire ends corrode, and garages that flooded in coastal storms have sensors that fail weeks later. Many homes have been raised since, with garages at ground level beneath them that are built to let water through. Along Rumson Road, large estates have carriage houses and multi-bay garages. On the inland streets and near downtown, older houses have smaller detached garages. Wind-blown sand and salt film on the lens are the everyday cause.

Why a garage door refuses to close

  • Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
  • Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
  • Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
  • Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.

Three safe checks before you call

  1. Look at the small lights on both sensors. Each should be on and steady.
  2. Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
  3. Gently turn the blinking sensor until its light goes steady, then try the remote again.

If that doesn't do it, stop there. Don't tape the sensors together or bypass them.

How the repair is done

The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.

Around Rumson

  • Inland streets: Smaller homes on modest lots away from the water.
  • Downtown: Around River Road's shops, with older homes and tight garages.

See the full Rumson service area.

Garage door won't budge? Call first, force it never.

Springs and cables hold a lot of tension. Don't lift the door by hand or keep pressing the opener; call and we'll book a technician.

Call (848) 272-3411
Call (848) 272-3411